Hello,
I'm trying to install yambo-4.2.4, but I have a problem with the creation of yambo interfaces, specifically after I type: make yambo interfaces, I obtain the following error:
checking for m4... no
configure: error: Cannot find m4 utility. Install m4 and try again.
Makefile:35: recipe for target 'configure-stamp' failed
make[1]: *** [configure-stamp] Error 1
make[1]: Leaving directory '/home/davide/yambo-4.2.4/lib/netcdf'
Makefile:141: recipe for target 'ext-libs' failed
make: *** [ext-libs] Error 2
(the Config.log file is attached)
thank you very much in advance!
Best regards,
Davide
Optoelectronics Research Centre,
University of Southampton, UK
Problem with creating yambo interfaces
Moderators: Davide Sangalli, andrea.ferretti, myrta gruning, andrea marini, Daniele Varsano, Conor Hogan, Nicola Spallanzani
Forum rules
If you have trouble compiling Yambo, please make sure to list:
(1) the compiler (vendor and release: e.g. intel 10.1)
(2) the architecture (e.g. 64-bit IBM SP5)
(3) if the problems occur compiling in serial/in parallel
(4) the version of Yambo (revision number/major release version)
(5) the relevant compiler error message
If you have trouble compiling Yambo, please make sure to list:
(1) the compiler (vendor and release: e.g. intel 10.1)
(2) the architecture (e.g. 64-bit IBM SP5)
(3) if the problems occur compiling in serial/in parallel
(4) the version of Yambo (revision number/major release version)
(5) the relevant compiler error message
-
dp5c14
- Posts: 2
- Joined: Fri Jul 27, 2018 3:21 pm
Problem with creating yambo interfaces
You do not have the required permissions to view the files attached to this post.
-
Daniele Varsano
- Posts: 4213
- Joined: Tue Mar 17, 2009 2:23 pm
- Contact:
Re: Problem with creating yambo interfaces
Dear Davide,
it seems you do not have the m4 utility in your machine.
Have a look at these two threads and see if this solve your problem:
https://www.unidata.ucar.edu/support/he ... 13331.html
https://unix.stackexchange.com/question ... al-install
Best,
Daniele
it seems you do not have the m4 utility in your machine.
Have a look at these two threads and see if this solve your problem:
https://www.unidata.ucar.edu/support/he ... 13331.html
https://unix.stackexchange.com/question ... al-install
Best,
Daniele
Dr. Daniele Varsano
S3-CNR Institute of Nanoscience and MaX Center, Italy
MaX - Materials design at the Exascale
http://www.nano.cnr.it
http://www.max-centre.eu/
S3-CNR Institute of Nanoscience and MaX Center, Italy
MaX - Materials design at the Exascale
http://www.nano.cnr.it
http://www.max-centre.eu/
-
dp5c14
- Posts: 2
- Joined: Fri Jul 27, 2018 3:21 pm
Re: Problem with creating yambo interfaces
Thank you very much!
Best regards,
Davide
Best regards,
Davide