about the error when calculating lifetime
Posted: Sat Sep 20, 2014 10:32 am
Hi everyone,
I use QE/Yambo to calculte the lifetime of Al(fcc).First I used QE to calculte KS states of Al(the k-points 10*10*10 and 20 bands),
then run yambo to calculte lifetime,everything is fine. BUT when I increase k-points(12*12*12) in the inputfile of QE,after running
yambo,error occures like this:
[ERROR] STOP signal received while in :[04.03] Dynamical Dielectric Matrix
[ERROR]Incomplete Parallel Index Filling
I don't know how to figure it out.
Thanks!
Kejun Zhang
I use QE/Yambo to calculte the lifetime of Al(fcc).First I used QE to calculte KS states of Al(the k-points 10*10*10 and 20 bands),
then run yambo to calculte lifetime,everything is fine. BUT when I increase k-points(12*12*12) in the inputfile of QE,after running
yambo,error occures like this:
[ERROR] STOP signal received while in :[04.03] Dynamical Dielectric Matrix
[ERROR]Incomplete Parallel Index Filling
I don't know how to figure it out.
Thanks!
Kejun Zhang