Page 1 of 1
[ERROR][NetCDF]
Posted: Fri May 15, 2009 11:52 am
by cudazzo
Dear all,
I' m running yambo to solve the Bethe Salpeter eq. on a k points mesh 30x30x1 (nkpt=452), but the code gives the following error message:
"P01: [ERROR] STOP signal received while in :[08.02] Main loop
P01: [ERROR][NetCDF] No such file or directory"
However using a smaller mesh (16x16x1) the code does not give any problems.
Is the problem related to the dimension of the files, or to the disk space?
Re: [ERROR][NetCDF]
Posted: Fri May 15, 2009 12:19 pm
by myrta gruning
cudazzo wrote:Dear all,
I' m running yambo to solve the Bethe Salpeter eq. on a k points mesh 30x30x1 (nkpt=452), but the code gives the following error message:
"P01: [ERROR] STOP signal received while in :[08.02] Main loop
P01: [ERROR][NetCDF] No such file or directory"
However using a smaller mesh (16x16x1) the code does not give any problems.
Is the problem related to the dimension of the files, or to the disk space?
Yes, it may be a problem related to the fact the ndb.* becomes larger than 2GB. I also got strange messages from the Netcdf in that case (even though this seems new to me). I am not a netcdf guru, but as I said I experienced some similar chrashes, so here some suggestions, I hope they may help you.
One way to prevent problems with large ndb.* (usually) is to invoke Yambo with the -S keyword that fragmented the database (yambo -H).
However, if you did not use this keyword from the beginning and you have a RESTART directory (and the calculations took already some time so that starting from scratch is not a good option) restarting with -S may cause a little mess (at least I was able to generate a mess in such a case).
Another option (maybe safer in the restart case) is to reconfigure Yambo with --enable-largedb feature (for more info ./configure --help in the yambo dir) that should enable netcdf to work with files larger than 2GB (even though I do not know exactly if this is possible only for 64 bits archs, and how this may affect performance, I/O etc.), and see if the program get over the point where it crashes now.
Cheers,
m
Re: [ERROR][NetCDF]
Posted: Fri May 15, 2009 1:48 pm
by Conor Hogan
Another common reason for this error is that the netCDF databases have not been created properly for some reason. Check that the SAVE directory contains a directory wf_0000n_... for every k-point used, and particularly that the size of all the SAVE/wf*/ndb.fragment files are about the same. It may simply be that you have to run a2y/p2y again.