Dear YAMBO developer,
I have an issue in running Yambo with the version yambo-master.So, when I use p2y it runs successfully. However, if I try to run the second step using 'yambo' I get the following message error:
~> yambo
yambo: cannot access CORE database (SAVE/*db1 and/or SAVE/*wf)
Sorry to bother if there is already a reply in the forum I did not see.
Sorry to send it here but I couldn't send it in the right place. I didn't find the adress.
best,
help for make interface with pwscf
Moderators: Davide Sangalli, andrea.ferretti, myrta gruning, andrea marini, Daniele Varsano, Conor Hogan, Nicola Spallanzani
Forum rules
If you have trouble compiling Yambo, please make sure to list:
(1) the compiler (vendor and release: e.g. intel 10.1)
(2) the architecture (e.g. 64-bit IBM SP5)
(3) if the problems occur compiling in serial/in parallel
(4) the version of Yambo (revision number/major release version)
(5) the relevant compiler error message
If you have trouble compiling Yambo, please make sure to list:
(1) the compiler (vendor and release: e.g. intel 10.1)
(2) the architecture (e.g. 64-bit IBM SP5)
(3) if the problems occur compiling in serial/in parallel
(4) the version of Yambo (revision number/major release version)
(5) the relevant compiler error message
-
lamia
- Posts: 68
- Joined: Mon Dec 05, 2016 5:09 pm
Issue in running Yambo
Taouil Lamia
University of Mohammed V
Faculty of science - Rabat
Morocco
University of Mohammed V
Faculty of science - Rabat
Morocco