Yambo Community Forum

Hi Yambos,

I follow the instruction for ypp -k k. I am on the step with Yambo calculating
generic points from 7 to 16 (6 were regular). I copied ndb.pp.* files from the
regular-grid GW calculations and obtained what is in written in the tutorial
" [05] Dynamic Dielectric Matrix (PPA)
====================================
[WARNING]Wrong serial number for ./SAVE//ndb.pp
[RD./SAVE//ndb.pp]------------------------------------------"

and later some info which is normal.

Unfortunatelly, at the end my calculations are hanging (for a few hours)
with an ERROR

CpuTiming [Min/Max/Average]: 09m-31s/09m-31s/09m-31s
[06] Bare local and non-local Exchange-Correlation
==================================================
[EXS] Plane waves : 19653
QP @ K 007 - 016 : b 073 - 080
[WF] Performing Wave-Functions I/O from ./SAVE
[FFT-HF/Rho] Mesh size: 75 75 12
[WF loader] Normalization (few states) min/max :0.223E-09 0.999
[ERROR] STOP signal received while in :[06] Bare local and non-local Exchange-Correlation
[ERROR]EMPTY WF index @ b:1 k:0 spin:1 ID:0

I killed the jobs. What should I do now?

Best regards,
Gosia Wierzbowska

Hi Gosia,
can you please post the report files of your calculation?

Best,
Daniele

Hi Daniele,
thank you.

I made a short test for this (C wire)
The error is in slurm-error file (job hangs)
Reports and inputs attached.

Gosia

Thank you Gosia for reporting,
I will try to reproduce the error and fix it as soon as possible.

Best,

Daniele

Hi Gosia,
could please also post the ypp input file you used to generate generic points and the yambo input for the GW on the second run (extended points).

Thanks,

Daniele

Thank you Daniele very much.
Here are the inputs.