Yes that run was with the haydock solver (note BSSmod="h" in the input file). I've attached a config.log file for the same configuration call.
I also tried modifying the ./config/setup file as pictured below since the report file said I could. I replaced all instances of 'serial' with 'parallel', and changed '--disable-parallel' to '--enable-parallel'. This resulted in it saying it was using the parallel directories for hdf5, but it still had parallel io turned off. The compilation finished, but unfortunately my 8x8x8 run failed in exactly the same way again.
The same error refers to
Code: Select all
Writing File ./conv_k//ndb.BS_Q1_CPU_0; Variable BSE_RESONANT; NetCDF: HDF error
Segmentation fault error only occurs when I try to use MPI parallelization as well. I guess it did seem to get a step further with MPI parallelization, so I'll try using that with the haydock solver, but I don't think this solves the parallelization issue you've discovered. I'll also try looking for more instances of 'serial' in the configuration files and see if changing them helps. Interestingly, when I configure yambo-5.0.4 and yambo-4.5.3 parallel-io appears to be enabled just fine (although the 'make all' call fails for other reasons that I don't want to figure out right not). Let me know if you have any more ideas.
Thanks again for all the help!
-Miles