p2y

Having trouble compiling the Yambo source? Using an unusual architecture? Problems with the "configure" script? Problems in GPU architectures? This is the place to look.

Moderators: Davide Sangalli, andrea.ferretti, myrta gruning, andrea marini, Daniele Varsano, Conor Hogan, Nicola Spallanzani

Forum rules
If you have trouble compiling Yambo, please make sure to list:
(1) the compiler (vendor and release: e.g. intel 10.1)
(2) the architecture (e.g. 64-bit IBM SP5)
(3) if the problems occur compiling in serial/in parallel
(4) the version of Yambo (revision number/major release version)
(5) the relevant compiler error message
Post Reply
kazemoor
Posts: 37
Joined: Tue Jun 22, 2010 6:27 am

p2y

Post by kazemoor » Tue Jun 22, 2010 8:24 am

Dear All
I am new in Yambo.I have a problem in compiling Yambo interfaces.
The configuration was performed successfully and But when I make yamboo interfaces in bin directory I have yambo and a2y but not p2y.
Because I am working with pwscf I need to compile p2y.
Thanks a lot
Ali Kazempour
Isfahan University of Technology,Physics Dept,Iran
Top
User avatar
Daniele Varsano
Posts: 3816
Joined: Tue Mar 17, 2009 2:23 pm
Contact:
Contact Daniele Varsano

Re: p2y

Post by Daniele Varsano » Tue Jun 22, 2010 9:16 am

Dear Ali,
the problem is most probably that you have not properly linked the iotk libraries.
If they are properly linked you should have a cross on the p2y support legend when
the configure is performed. If you can't solve the problem, please post the config.log
file.

Best,

Daniele
Dr. Daniele Varsano
S3-CNR Institute of Nanoscience and MaX Center, Italy
MaX - Materials design at the Exascale
http://www.nano.cnr.it
http://www.max-centre.eu/
Top
Post Reply

Return to “Compilation”